|REVIEW PAPER EXPERIMENTAL STUDY ON BEHAVIOUR OF CONCRETE BY CETP SLUDGE|
|PRASHANT RAY, PROF. JUGAL S MISTRI|
|Cite This Article:|
REVIEW PAPER EXPERIMENTAL STUDY ON BEHAVIOUR OF CONCRETE BY CETP SLUDGE, International Journal of Innovative Research in Technology(www.ijirt.org) ,ISSN: 2349-6002 ,Volume 5 ,Issue 9 ,Page(s):71-75 ,February 2019 ,Available :IJIRT147570_PAPER.pdf
|Cement, F.A-Fine Aggregate, C.A.-Coarse Aggregate, CETP Sludge, Polypropylene fiber compressive strength, flexure strength test ,split tensile strength|
|Leaving the waste material to the environment directly cause environmental problems. Rapid Industrialization and Urbanization is causing serious environmental problems to the environment. One of the major concerns amongst these is safe and sound disposal of solid wastes. The treatment of effluents from the production of industries results in sludge generation from the treatment plant which poses a huge challenge for its disposal. Therefore, an attempt is made to initialize them in an effective way. In this experimental investigation, an attempt has been made to investigate the behaviour of concrete and its mechanical properties with replacement of cement with CETP sludge. The outcomes show there is a possibility in accommodating the sludge in concrete by solidification. This report is meant for discussion of beneficial utilization of CETP sludge waste with conventional building material in Construction application. From this study, the use of the CETP sludge will be identified for structural and non-structural applications by conducting future experimental studies. To evaluate the effect of dry sludge on concrete performance, its physical and mechanical properties were studied. In this research an attempt is taken to bring into play the sludge waste in various proportions so that the final product property of concrete mixture is same as the control mix. Waste sludge material will be replace cement in various percentages such as 20%,15%, 10%,5% ,and 0%. Reference concrete mix is to be also made for comparative reasons. Test will be conducted on fresh and harden concrete. Cube, cylinder and beam will be casted for grade M30 for the determination of workability, compressive strength, tensile strength and flexure strength.|
|Unique Paper ID: 147570|
Publication Volume & Issue: Volume 5, Issue 9
Page(s): 71 - 75
|Article Preview & Download|
Virtual Instrumentation: An oscilloscope based on ...
Paper ID : IJIRT148798
Heat Transfer Augmentation Using Twisted Tape Inse...
Paper ID : IJIRT148786
SOFTWARE ARCHITECTURAL STYLES IN THE INTERNET OF T...
Paper ID : IJIRT148785
Comprehensive Analysis of Energy Aware Clustering ...
Paper ID : IJIRT148784
Performance Analysis of Solar Water Heater Evacuat...
Paper ID : IJIRT148783