Copyright © 2025 Authors retain the copyright of this article. This article is an open access article distributed under the Creative Commons Attribution License which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

@article{150870,
        author = {Suresh S Chougule and Prof.(Dr.) G. R. Naik and Prof. R. S. Patil},
        title = {Optimization of process parameters of turning using various tool geometry of cemented carbide inserts (CNMG) for hardened AISI420 stainless steel material   },
        journal = {International Journal of Innovative Research in Technology},
        year = {},
        volume = {7},
        number = {10},
        pages = {181-185},
        issn = {2349-6002},
        url = {https://ijirt.org/article?manuscript=150870},
        abstract = {The objective of this paper is to obtain an optimum setting of turning parameters for to get an optimum value of surface roughness and MRR while machining AISI420 stainless steel using CNMG inserts. Turning process parameters included spindle speed, feed, depth of cut and insert nose radius. A total number of 9 experiments conducted with orthogonal array.  Attempt has been made to optimize the process parameters using Taguchi method. Minitab statistical software used for the analysis of the experimental work. After experimentation and analysis it shows that feed affects greatly on MRR followed by DOC.  For to achieve maximum MRR all process parameters has to be at level 3.  In case of surface roughness, feed is a major influencing parameter followed by insert nose radius. To get good surface finish spindle speed, DOC, insert nose radius to be at level 3 and feed has to be at level 1. 

},
        keywords = {Turning process, MRR, surface roughness, Taguchi method, S/N ratio, carbide inserts, Minitab software.},
        month = {},
        }