Copyright © 2025 Authors retain the copyright of this article. This article is an open access article distributed under the Creative Commons Attribution License which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

@article{153467,
        author = {Nitesh Kumar and Gopal Krushna Mohanta and Sibabrata Mohanty},
        title = {OPTIMIZATION OF WEDM PROCESS PARAMETER ON MACHINING OF ALUMINIUM REINFORCED WITH FLY ASH},
        journal = {International Journal of Innovative Research in Technology},
        year = {},
        volume = {8},
        number = {7},
        pages = {275-280},
        issn = {2349-6002},
        url = {https://ijirt.org/article?manuscript=153467},
        abstract = {In this present investigation aluminium composite reinforced with fly ash fabricated by stir casting process. The objective of the research work is to optimize the Wire EDM process parameters such as input current, pulse on time, pulse off time, wire feed for the surface roughness and material removal rate of aluminium matrix composites (AMCs).The experimental work has been carried out by using Taguchi L9 orthogonal array under appropriate combination of process parameter. Analysis of variance (ANOVA) used to find out the design parameter how significantly influencing the responses. To evaluate the influence of these parameter Signal to Noise(S/N) ratio analysis has been done. The result shows the optimum combination of parameter which give the maximum metal removal rate and minimum surface roughness.},
        keywords = {AMCs, WEDM, S/N ratio, ANOVA, Metal Removal Rate, Surface Roughness },
        month = {},
        }