Copyright © 2026 Authors retain the copyright of this article. This article is an open access article distributed under the Creative Commons Attribution License which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

@article{154491,
        author = {Varna K and lakshmidevamma M M and Vijay Kumar S and Varadaraj K R and Satya Prema },
        title = {Comparative study on temperature during machining of Al6061 and Al7075 reinforced with Al2O3 using statistical analysis},
        journal = {International Journal of Innovative Research in Technology},
        year = {},
        volume = {8},
        number = {11},
        pages = {572-578},
        issn = {2349-6002},
        url = {https://ijirt.org/article?manuscript=154491},
        abstract = {The present paper focused on temperature measurement during machining of Al6061 by considering the Al2O3 as the reinforcement with an interval of 2% from 1% to 9% respectively. The experimental investigations were conducted using operational parameters such as feed rate, depth of cut, and spindle speed. However, in the case of 9% Al2O3, there is a temperature variation for spindle speed, with a progressive increase in temperature from 28.4ï‚°C to 35.4ï‚°C for 0.10 mm/sec to 0.20 mm/sec and 0.50mm to 1.25mm of feed rate and depth of cut for Al7075 combinations. Whereas, influence parameters in temperature was determine and the average temperature for the combinations considered. It is clearly shows that for the 0% Al2O3 the temperature was 32.46ï‚°C and for 9% Al2O3 the temperature was 28.91ï‚°C for Al6061.},
        keywords = {Al7075, temperature, prediction, ANOVA, statistical analysis. },
        month = {},
        }