|Fabrication Of Model Using Pneumatic System For Unloading Wagon|
|Utkarsh G. Pipare, Atul L. karande, Niranjan Kumar, Amit T. Rahangdale, swapnil Marathe|
|Cite This Article:|
Fabrication Of Model Using Pneumatic System For Unloading Wagon, International Journal of Innovative Research in Technology(www.ijirt.org) ,ISSN: 2349-6002 ,Volume 5 ,Issue 10 ,Page(s):241-244 ,March 2019 ,Available :IJIRT147696_PAPER.pdf
|SMPS, PTT, FRC|
|the project being complicated was decide to be developed on a small scale model that should be constructed using light weight material and should be pneumatically operated using pneumatic cylinder arrangement. Also this pneumatic piston and cylinder arrangement was decided to be motor driven to make the same automatic. These motor run using a battery/ SMPS and are controlled using a remote control that is attached with the base model using wires / FRC cable and these after controlled by operator.|
|Unique Paper ID: 147696|
Publication Volume & Issue: Volume 5, Issue 10
Page(s): 241 - 244
|Article Preview & Download|
Virtual Instrumentation: An oscilloscope based on ...
Paper ID : IJIRT148798
Heat Transfer Augmentation Using Twisted Tape Inse...
Paper ID : IJIRT148786
SOFTWARE ARCHITECTURAL STYLES IN THE INTERNET OF T...
Paper ID : IJIRT148785
Comprehensive Analysis of Energy Aware Clustering ...
Paper ID : IJIRT148784
Performance Analysis of Solar Water Heater Evacuat...
Paper ID : IJIRT148783