|An analysis of three different die profile for cold extrusion process|
|ShubhamShrivastava, K.K. Jain|
|Cite This Article:|
An analysis of three different die profile for cold extrusion process, International Journal of Innovative Research in Technology(www.ijirt.org) ,ISSN: 2349-6002 ,Volume 5 ,Issue 11 ,Page(s):33-37 ,April 2019 ,Available :IJIRT147850_PAPER.pdf
|Extrusion, die design, die shapes, Cosine Die, Third-order polynomial Die and conical die.|
|In the present work, three different die shapes have been considered i.e. Third-order polynomial die, Cosine die and Conical die. AL 1100-O is used as the filler material for all the three dies. The material to be extruded was modelled as a perfect plastic material for the non-linear analysis during the finite element simulation. Output from the finite element program included Directional deformation, at different Die Pressure i.e. 800 MPa, 1200 MPa and 1600 MPa. Based on the finite element analysis results the Cosine die is best among all the three-die considered for the study i.e. Cosine Die, Third-order polynomial Die and conical die.|
|Unique Paper ID: 147850|
Publication Volume & Issue: Volume 5, Issue 11
Page(s): 33 - 37
|Article Preview & Download|
STRUCTURAL AND GEOMORPHOLOGICAL EVOLUTION OF THE A...
Paper ID : IJIRT148947
HYDROGEOCHEMICAL STUDIES OF ERRIMULLIVAGU BASIN, R...
Paper ID : IJIRT148946
Banded Magnetite Quartzite in Southern Granulite T...
Paper ID : IJIRT148945
MODELLING OF RENEWABLE ENERGY SOURCE FED ACTIVE BU...
Paper ID : IJIRT148944
Eco-friendly & Free Cooling Obtained by Thermoacou...
Paper ID : IJIRT148943