Design and Fabrication of Automatic Water Filling Machine using Geneva Mechanism

velmurugan M; Gopinath K; RAMPRASANNA M; Hariprasath R

Design and Fabrication of Automatic Water Filling Machine using Geneva Mechanism

Authors: velmurugan M, Gopinath K, RAMPRASANNA M , Hariprasath R

Unique Paper ID: 147662
Volume: 5
Issue: 10
PageNo: 144-148

Keywords: Geneva mechanism Sensors Modified Six Slotted Geneva Intermittent Motion

Abstract:
The main objective of our project is to fill water automatically by using Geneva mechanism. Geneva or Maltese cross mechanism is an indexing mechanism that converts continuous motion into intermittent motion. In our project we are using modified six slotted Geneva drive to fill water automatically without the usage of sensor. The rotating drive wheel is usually equipped with a pin that reaches into a slot located in the driven wheel. The driven wheel or Geneva drive consist of six slot that advances it by one step at a time. This mechanism is to control the rotating table slowly. And the cam is used to control the flow on & off of water automatically instead of using sensors. Geneva drive and cam are connected in the same shaft to obtain the process efficiently. Finally the rotating table which contains the water bottle container which receives the water at a periodic time without any usage of sensor.

Download article

email to a friend

Cite This Article

ISSN: 2349-6002
Volume: 5
Issue: 10
PageNo: 144-148

Design and Fabrication of Automatic Water Filling Machine using Geneva Mechanism

Available:https://ijirt.org/Article?manuscript=147662

11 Mar, 2019

Design and Fabrication of Free-Free Beam

Impact Factor
8.01 (Year 2024)

UGC Approved
Journal no 47859

Join Our IPN

IJIRT Partner Network

Submit your research paper and those of your network (friends, colleagues, or peers) through your IPN account, and receive 800 INR for each paper that gets published.

Join Now